PSS PS600 Návod k obsluze stáhnout pdf (Strana 38)

Troubleshooting

The table below lists the possible causes and any corrective actions required for

conditions that may occur with your machine. For conditions not covered below, contact

your Pressure Seal Systems distributor.

Condition Possible Cause Corrective Action

The power-on indicator

does not light.

Mains lead not plugged into

an AC outlet.

Plug mains lead into an AC

outlet.

Mains plug fuse blown. Replace fuse. If the

replacement fuse blows,

contact your Pressure Seal

distributor for advice.

Board fuse blown. Contact your Pressure Seal

distributor for advice.

The machine does not

operate when the On/Start

button is pressed (power

on)

Form misfeed, jam detected:

error message displayed.

Clear mishandled forms.

No forms loaded. Load forms.

Board fuse blown. Contact your Pressure Seal

distributor for advice.

Forms are mishandled in the

folder or damaged during

sealing.

Fold plate form stop(s)

adjusted improperly.

Check and adjust the

position of the fold plate

form stop(s). See page 16.

Debris in folding plates;

folding plates not installed

properly; fold plate form

stop(s) adjusted improperly.

Remove debris; properly

install fold plates; check

position of the fold plate

form stop(s).

5. Operation Errors PS 600

Page 36 22-01-03 Iss. B.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 46 47

Komentáře k této Příručce

Žádné komentáře

PSS PS600 Návod k obsluze Strana 38

Komentáře k této Příručce